Bacharach PCA3 Especificaciones descargar pdf (Pagina 45)

PCA



3 Manual

0024-9473 Rev 4 45

5.2. Turning On the Analyzer

1. Connect the probe and hose assembly, and make sure that the analyzer

is properly set up according to Initial Setup (page 21) and Configuration

Procedures (page 24).

IMPORTANT:

DO NOT insert probe into stack before

turning ON the analyzer!

2. Place the probe in an area that contains fresh air. This ensures that the

sensors will be properly zeroed during the warm-up cycle.

3. Turn ON the analyzer by pressing the I/O button for at least 1 second, or

until a single beep is heard. Observe that the analyzer’s firmware

version, model and serial numbers are briefly displayed followed by the

Warm Up screen.

4. Wait for the analyzer to count down its 60-second warm-up period, after

which, the instrument will display the Combustion Test HOLD screen.

5. If problems were detected during warm up, the message “ERRORS

DETECTED” is displayed along with a list of those errors. As an

example, the screen below shows that the battery is low. Refer to Error

Messages (page 93) for a listing and possible remedy for the errors

displayed.

NOTE:

If the sensors in error are not critical to the

combustion test, then press the RUN/HOLD

button to

display the Combustion Test HOLD screen and proceed

with the test.

Figure 5-1. Turning On the Analyzer and Warm-up

5.3. Low Battery Alarm

When the batteries are nearly depleted, an empty battery icon appears in the

upper right corner of the display, and a short beep is sounded every 10

seconds.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 103 104

Sin comentarios

Bacharach PCA3 Especificaciones Pagina 45