Bacharach PCA2 Especificaciones Pagina 60
- Pagina / 116
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Instruction 24-9448 4-17
Operation
4.14.4 Ending the Data Logging Process
Data logging will stop and the pump will turn OFF after the prescribed
duration, or after all 500 memory locations are filled.
To exit the Combustion Test LOG screen, press
the RUN/HOLD button twice to display the Com-
bustion Test HOLD screen.
Note the following:
• To end the logging process at any time, press
the ESC button.
• At the end of the logging period, or if the
ESC button was pressed, the total number
of log entries that were stored during that
period appear at the bottom of the screen.
• If the logging process was stopped by pressing ESC, it cannot be re-
sumed without first turning logging back ON per Section 4.12.1.
4.15 Memory
There are two memory banks, each containing 500 memory locations. The
first bank is used to store combustion test data as described in Section 4.7.,
while the second bank is used to store logged combustion test data as
described in Section 4.12. Each bank is independent of each other, and can-
not share data or be combined.
Individual memory locations in each memory bank can be recalled for
viewing on the display or printed (refer to Sections 4.13.1 & 4.13.2), or the
entire contents of each memory bank can be individually downloaded to a
computer and viewed in a spreadsheet program for analysis (refer to Sec-
tion 4.14).
TIP: When displaying the contents of either memory bank,
the operator can quickly page through the screens by press-
ing the PAGE– (F1) and PAGE+ (F3) buttons. Or move to
the first or last memory location by pressing the buttons,
respectively.
LOG NATURAL GAS
O2 4.0 %
CO 12 ppm
EFF 82.6 %
CO2 9.5 %
T-STK 374 °F
T-AIR 68.0 °F
EA 21.3 %
CO(3) 13 ppm
yy Entries Stored
F1 F2 F3
Where: “yy” is the number of
log entries stored during the
last logging session.
- Portable Combustion Analyzer 1
- WARRANTY 2
- Contents 3
- Instruction 24-9448 4
- 1 Introduction 7
- Instruction 24-94481-2 8
- Instruction 24-9448 1-3 9
- 1.3 Features & Benefits 10
- 1.4 Operational Overview 11
- 1.5 Connector Descriptions 12
- Figure 1-1. PCA 2 Components 13
- 1.5.3 POWER (AC Adapter) 14
- 1.6 Front Panel Buttons 15
- Instruction 24-94481-10 16
- Introduction 16
- 2 Specifications 17
- Normal Operating Conditions: 18
- Performance: 18
- Instruction 24-9448 2-3 19
- Specications 19
- Instruction 24-94482-4 20
- 3 Initial Setup 21
- 3.1 Scope 21
- 3.2 Power 21
- Instruction 24-94483-2 22
- Initial Setup 22
- T-STACK T-AIR 23
- 3.4 Operating Parameters 24
- 3.5 Fuel Selection 24
- Instruction 24-9448 5 25
- 3.7 Pressure Units Selection 26
- Instruction 24-9448 7 27
- 3.9 Date Setup 28
- 3.10 Time Setup 29
- Reference Setup 30
- Instruction 24-9448 11 31
- O2 4.0 % 32
- CO 12 ppm 32
- EFF 82.6% 32
- Instruction 24-9448 13 33
- 3.15 Logging Selection 34
- 3.16 Button Sound 34
- 3.17 Test ID Information 35
- Instruction 24-944816 36
- 3.18 Username 37
- Instruction 24-944818 38
- 3.19 Language 39
- 3.20 Cal Reminder Period 40
- 3.21 Run/Hold Screen Format 41
- Instruction 24-944822 42
- Instruction 24-9448 23 43
- 4 Operation 44
- 4.1 Operating Tips 44
- --- % 45
- T-STK 71.5 °F 45
- T-AIR 71.5 °F 45
- EA --- % 45
- CO(0) --- ppm 45
- 4.3 Selecting a Fuel 46
- 4.4 Sampling Point 47
- Instruction 24-9448 4-5 48
- Operation 48
- 4.6 Pressure Label Selection 50
- Instruction 24-94484-8 51
- 4.9 Saving Test Data 53
- 4.10 Ending a Combustion Test 54
- 4.11 Emptying the Water Trap 54
- 4.13 Low Battery Alarm 55
- 4.14 Data Logging 56
- Instruction 24-94484-14 57
- Instruction 24-9448 4-15 58
- Instruction 24-94484-16 59
- Where: “xx” is the memory 59
- 4.15 Memory 60
- Instruction 24-94484-18 61
- Instruction 24-9448 4-19 62
- 4.15.3 Clearing Memory 63
- Instruction 24-9448 4-21 64
- Instruction 24-9448 4-23 66
- Instruction 24-94484-24 67
- Select (Advanced) 68
- Name of new USB 68
- Instruction 24-9448 4-25 68
- 4.16.3 Recovering Data 69
- Instruction 24-9448 4-29 72
- Instruction 24-94484-30 73
- 4.18 Printing Test Data 74
- ∗∗∗) appear in the data 75
- Instruction 24-9448 4-33 76
- 5 Calibration 77
- 5.1 Smart Sensors 77
- 5.2 Starting a Calibration 77
- 5.3 Pressure Sensor 78
- Calibration 78
- 5.4 T-Stack Calibration 80
- ENT to calibrate the TS-Zero 81
- ENT to cali 81
- 5.5 T-Air Calibration 82
- Instruction 24-9448 5-7 83
- 5.6 CO-LO Sensor Calibration 84
- ENT to calibrate the H 85
- Sensor Calibration 86
- 5.8 NO Sensor Calibration 87
- ENT to calibrate the NO 89
- ENT to display 89
- 6 Maintenance 91
- 6.1 PCA 2 Disassembly 92
- Type and position 93
- +∆P (Top) 93
- –∆P (Bottom) 93
- PRESSURE 94
- PURGE AIR 94
- Figure 6-4. Wiring 95
- Instruction 24-94486-6 96
- 6.3 Smart Sensor Replacement 97
- 6.4 Sensor Only Replacement 98
- Instruction 24-9448 6-9 99
- Instruction 24-94486-10 100
- Maintenance 100
- 6.6 Thermocouple Replacement 101
- Instruction 24-94486-12 102
- 6.7 Pump Replacement 103
- 6.8 Cleaning the Probe 104
- 7.1 Analyzer Repair 105
- 7.2 Error Symbols 105
- 7 Troubleshooting 105
- Instruction 24-94487-2 106
- Troubleshooting 106
- ENT to display the 107
- ENT to display the DEVICE 108
- 8 Parts & Service 109
- 8.1 Replacement Parts 109
- Figure 8-1. Parts (2 of 2) 111
- 8.2 Accessories 112
- Instruction 24-9448 8-5 113
- Parts & Service 113
- 8.3 Service Centers 114
- Printed in U.S.A 116
Relacionado con productos y manuales para De medición, control y control Bacharach PCA2
AEG HK854401IB Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Kochfelder AEG HK854401IB.
Wir stellen 2 PDF-Handbücher AEG HK854401IB zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Inhaltsverzeichnis
CONTENTS
2
4.7 Timer
10
4.8 STOP+GO
10
4.9 Lock
10
ENGLISH 13
13
8.4 Assembly
18
5. CONSEILS
34
Hob²Hood
36
FRANÇAIS
39
< 20 mm
41
> 20 mm
41
Personen
45
2.3 Gebrauch
48
8. MONTAGE
62
DEUTSCH 67
67
Inhaltsverzeichnis
CONTENTS
2
> 20 mm
18
< 20 mm
18
CONTENIDO
21
3 pasos)
27
5. CONSEJOS
32
ESPAÑOL 33
33
Hob²Hood
34
ESPAÑOL 43
43
Weitere Produkte und Handbücher für Kochfelder AEG
| Modelle | Dokumententyp |
|---|---|
| HK634020FB |
Bedienungsanleitung
   
Aeg HK634020FB Handleiding [sv] ,
68 Seiten
|
| HG694340XB |
Bedienungsanleitung
Aeg HG694340XB User Manual,
20 Seiten
|
| 96901K-MNHIC90 |
Bedienungsanleitung
Aeg 96901K-MNHIC90 Handleiding,
84 Seiten
|
| HG65NM4320 |
Bedienungsanleitung
Aeg HG654320NM User Manual,
20 Seiten
|
| HK973500FB |
Bedienungsanleitung
Aeg HK973500FB User Manual [de] [es] [fr] ,
64 Seiten
|
| 79200KF-N | Bedienungsanleitung Aeg 79200KF-N Brugermanual, 72 Seiten |
| HKL65416FB |
Bedienungsanleitung
Aeg HKL65416FB User Manual,
72 Seiten
|
| HKL85410XB |
Bedienungsanleitung
Aeg HKL85410XB User Manual,
44 Seiten
|
| 6110M-MN 31J |
Bedienungsanleitung
Aeg 6110M-MN 31J User Manual,
32 Seiten
|
| 66300KF-AN98F |
Bedienungsanleitung
Aeg 66300KF-AN98F User Manual,
88 Seiten
|
| HK854326IB |
Bedienungsanleitung
Aeg HK854326IB User Manual [en] ,
68 Seiten
|
| HK624010XB |
Bedienungsanleitung
Aeg HK624010XB User Manual,
16 Seiten
|
| HK854401FB |
Bedienungsanleitung
Aeg HK854401FB User Manual,
68 Seiten
|
| IKE64443FB |
Bedienungsanleitung
Aeg IKE64443FB User Manual [fr] ,
24 Seiten
|
| IKB64443XB |
Bedienungsanleitung
Aeg IKB64443XB User Manual,
24 Seiten
|
| HG654440SM |
Bedienungsanleitung
Aeg HG654440SM Handleiding,
52 Seiten
|
| HK955423IB |
Bedienungsanleitung
Aeg HK955423IB Handleiding,
60 Seiten
|
| BE500472JM | Bedienungsanleitung Aeg BE500472JM Brukermanual, 40 Seiten |
| BP8715001M |
Bedienungsanleitung
Aeg BP8715001M Handleiding,
36 Seiten
|
| BE8012711M | Bedienungsanleitung Aeg BE8012711M Brukermanual [fr] , 48 Seiten |
© 2020, manymanuals.es. Todos los derechos reservados | 0.020 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales